The Art of Resurrection

“To know how a car works and how to repair it is to liberate oneself from an endless cycle of consumption.”

I know almost nothing about “how a car works and how to repair it” and it’s a little late in the game to hop off the “endless cycle of consumption,” but this article by Andrew Messick nicely sums up the appeal of my old vehicles. A few excerpts:

It was a good car, but it operated in a bland, even mundane, way. It performed every action I asked of it without complaint, without grumbling, without emotion, without any sort of personality. It was smart enough to tell me all of its ailments. A flashing exclamation point would show me a low tire. A phone notification would tell me my doors were unlocked. A gentle blue light would show it wasn’t quite warm enough to turn the heat on. But if I so much as put a wrench to the car, it would fall to pieces, and there would be nothing I could do to fix it due to its sheer complexity. 

This thing—this slow, lumbering piece of antiquity, this archaic hindrance to staying within the speed limit—has brought me more satisfaction than any flashy new car possibly could. There is an indescribable joy I experience when I pull the choke, press the starter button, and give a slight tap on the gas.

The new car, which was Disposable, was just a machine. Granted, it was a reliable, thoroughly trustworthy machine, but one lacking all soul, all sense of uniqueness. So mundane it blended into the parking lot, it had perfected the art of invisibility through being completely identical to everything around it.

But to own a car that requires only basic maintenance, something that one can do by themselves, to utilize that local corner mechanic, who may even be a staple of your community, to know your belongings beyond simply turning them on and using them, is to liberate oneself from the endless cycle of consumption.

It leaks when it rains. The “new car smell” passed from it decades ago. The factory optional heater—a drum of roughly coffee-can proportions with two small gates that either defogs your windshield or blows out a weak breath of lukewarm air onto your legs—achieves warmth that is only slightly better than freezing. Yet I would rather feel a waft of lukewarm air on my skin than pay a monthly subscription for seat heaters.

Jeep: Rethinking canvas top

My little homemade carport would work fine for a gentle, straight-down rain, but any little wind and the inside of the Jeep gets wet. Last night I threw a plastic tarp over the Jeep but that was a poor solution. Today I snapped on the “doors” of the custom canvas top and that’s going to work just fine. (Some of my resistance to the canvas top was due to the ugly-ass camo.)

I’ve been thinking of the Jeep as a warm weather ride but once I can safely drive the thing, I’m going to put the rest of the canvas top on and take it for a spin on a chilly day. The Jeep has a heater so we’ll see how it works.

Jeep Homecoming

After a day or two in the shop it was time for the Jeep to come home.

Since it was freeze-your-ass-off cold today, Paul kindly offered to trailer the Jeep to our place. Waiting to load.

We still need to do a little work on the poor man’s carport. I’m thinking maybe a roll-up tarp on the sides.
Tomorrow I’m going to spend some time with the owners manual and see if I can get the hang of the manual choke. The adventure begins.

Steering box replaced

The replacement steering box is in and the Jeep is almost ready to come home.The multicolored column is the perfect visual history.
Paul enlisted the help of some of his vintage car buddies (the cars, not the buddies). Here you see them working on the box after pulling the fender.


Too cold for much of a test drive but Paul took us for a quick spin around his property. Couple of minor tweaks and then we bring it home (on the first warm day). Looks so much better than that first day.

Fresh coat of paint for the Jeep

Paul hit a snag on replacing the broken steering box. Something about bearings and it means what he expected to be an easy job… won’t be. So no idea when I’ll finally get behind the wheel.

But it was a nice day so I put a fresh coat of paint on the roll bar and the tub. There are some brackets in the tub that I think will be perfect for safety anchors for the dogs’ harnesses. Not much left (that I can help with). I’ll paint the seats this week and finally say so long to the camo.
I put the jerry can in its mount, just to see how it looks. Very Jeepish but if it starts feeling like a big ass IED, I’ll leave it at home. AAA is my friend.
24 Hours Later: After thinking about it overnight, I decided to remove the jerrycan from the back of the Jeep. One, there was the Exploding Pinto consideration. Two, it is unlikely I’ll ever drive so far I need more fuel than the Jeep’s tank holds. And three, with the spare tire and the jerrycan the back of the Jeep would be too crowded. The vehicle just isn’t wide enough for all that stuff.

Less and less camo

While I’m grateful to the previous owners of the Jeep for all the good things they did for her, the camo paint job cannot be forgiven. But I’m fixing that, little by little.

Today I painted the dash (does a Jeep have a dash?). Not sure why anyone thought the inside of the Jeep needed to be camouflaged. Probably just liked the camo look as much as I hate it.

The dark spots in the photo above are where the spray paint hasn’t completely dried. Only remaining camo is the cover of the seats and that will be taking care of next week. Tomorrow, weather permitting, we’ll give the roll bar a fresh coat leaving only the inside of the tub.

All of this will get much easier when we can drive/steer the Jeep. Next day or so?

Jeep clean up

Sort of. I used the Shop-Vac to suck out the dust and gunk that had accumulated under the carpeting that lined the tub. Sponged it out in preparation for a coat of paint. Before that, however, Paul recommends going over the metal with Scotch-Brite pads (arrow).

The tailgate has been bolted closed because a) it’s pretty much useless and b) to accommodate a mounting bracket for the spare (arrow). Paul is very particular about wheels and tires and has located a rim that matches the ones on the vehicle. Still need to paint the jerry can mount and I think I might keep a few gallons strapped to the back of the Jeep. Took the top off again because I plan to paint the roll bar at the first opportunity.

The remaining photos are just for fun. The iconic Jeep grill; the tidy little engine; and a nice 3/4 view. The steering box scheduled for deliver by end-of-day tomorrow so I might a wheel to get behind in the next week.

First ride in the Jeep

While waiting for the new steering box I’ve been amusing myself with what I think of as de-junking the Jeep. Removed rusty old seat belts; pulled up nasty carpet; ditched the home-made tool box (there’s a perfectly good one under the passenger seat). Also a little spray paint touch-up. Still plan to yank the CB radio and the spotlights on the rollbar.

As I finished up Paul suggested to take the jeep for a little drive (steering with vice grips, of course). I was surprised by just how much land Paul, his brother and father have. (I believe he said 120 acres but I might be wrong about that.) Best part? Winding trails just wide enough for the Jeep (and other offroad vehicles, I assume).

Paul had no trouble steering with the vice grips and the Jeep did the offroad bits beautifully. But we mostly just moseyed along in first gear. This is going to be a fun ride.

UPDATE 2/6/23: The floor of the Jeep –front and back– was covered with a nasty black carpet. I much prefer the battered (?) metal. When I get the Jeep home I’ll wash it out good and give the tub a coat of paint.

I played with the canvas top a little and decided to just go with the top over the seats. Just not a fan of those plastic windows. I’ll wear my insulated coveralls when I need to drive in cold weather. (Man,I have got to adios those lights.)

Paul was able to remove the broken steering column and see what he needed to get the Jeep drivable. Parts on order. Getting closer.

Jeep now topless

hate camo and all that phrase has come to connote. When I saw the Jeep for the first time I thought, cool Jeep. My second thought was, that camo is fugly! Paul made the Jeep look much better with a few cans of spray paint. I’m going to try to do the same for the canvas top.

Thought it would be a chore to get the top off but Paul and I did it in about five minutes. Turns out the previous owner had the top custom-made by some upholstery wizard. When it was off Paul said he thought the Jeep looked happier.

I spread the pieces out on the floor of the big room in the Annex and masked the plastic “windows” in preparation for painting tomorrow. Curious if this will work at all and how many cans it might take. If it comes out okay, I’ll probably put it back on and drive the Jeep some this winter.

I also learned today the previous owner had a cover made for the Jeep. I was expecting a big old bag that covered the entire vehicle but this item looks custom, too.

Difficult to tell from this photo but it appears this just covers the interior with those two pouch-looking things for the seat backs. I don’t expect to worry much about the Jeep getting wet but we’ll see how easy this is to get on and off.

I’ve cobbled together a “carport” of sorts by covering the top of the Land Rover rack with a heavy duty tarp in hopes of keeping the worst of the weather off. (:54 video)

Update February 2, 2023: The spray job on the canvas top came out better than expected. Close enough to the color of the Jeep body.